Dealing with gases in your water well

Dissolved gases occur naturally in water wells but can lead to both quality and safety issues

Gases in water wells can cause some quality issues or even be a danger, says an agricultural water engineer with Alberta Agriculture and Forestry.

Gases can occur naturally in water wells after being dissolved in the water and released when pumped out of the well.

“Sometimes people complain about the smell, but the gases you can’t smell may cause the worst problems,” said Shawn Elgert. “Odourless gases include carbon dioxide, methane, and nitrogen, and potential dangers may arise from these gases in the water.”

Elgert says that water wells that ‘breathe’ have been fatal in Alberta.

“On a low-pressure day, gases can come out of the well head that can contain very little oxygen,” he said. “If the well head is inside a pumphouse, in the basement of a house — or even worse — in a pit, the oxygen in that enclosure can be displaced.

“It only takes a short time for a person in that enclosure to lose consciousness or even die if they breathe in this gas with little oxygen — even less time than if they try to hold their breath.”

Gases can collect in a basement if an older pressure tank or cistern is located there and not vented to the outside.

“However, modern pressure tanks do not have a relief valve, so this problem does not occur with them,” he said.

Another danger is when a combustible gas, such as methane, is present. A strong enough concentration could result in an explosion.

One well owner experienced this danger first hand, said Elgert.

“He was venting the gas out of a pressure tank inside a pumphouse because he thought the pump was introducing air into the water. He was near the pump when it kicked on, created a spark, ignited the gas, and blew up the pumphouse while he was still inside. He was fortunate it was such a short burn and he only sustained minor peeling of skin from his face after the incident.”

Overpumping the well can make this problem worse especially when the water level is drawn below the top of the slots or holes in the casing where the water enters the well.

“Other problems can occur on a high-pressure day in winter,” said Elgert. “Air can go down into the well, freeze the pitless adapter, and stop the water from pumping. Gases causing spurting from taps and loss of prime of the pump is another problem.”

Elgert offers these tips:

  • Wells in pits should only be worked on by someone with confined space entry training. Well drillers use gas meters to determine if there is enough oxygen in the pit before entering. The meters also test for some other gases including combustible ones.
  • Existing wells in pumphouses or unsealed wells in basements should be capped properly and vented safely to the outside. Older-style pressure tanks in basements that can vent off should be vented to the outside.
  • Overpumping the well can intensify the problem. An assessment of the well can be done to determine a system that would reduce overpumping.
  • Collect a sample with an appropriate method and send it to an accredited laboratory for analysis.

For more information, read “Gas in your Water Well,” visit “Dissolved Gases in Well Water” on the Alberta Agriculture website, or call the Alberta-Ag Info Centre at 310-FARM (3276).

About the author

Comments

explore

Stories from our other publications